TAKE YOUR BUSINESS TO NEW HEIGHTS

 Now you can offer your customers truly low-pressure roof cleaning

Clean highly profitable steep pitched roofs without getting on them

and best of all advertise

 "NO DAMAGING HIGH PRESSURE USED"

CLEAN STEEP PITCHED ROOFS EITHER FROM THE EDGE OR SITTING ON THE RIDGE (some single story roofs may be cleaned from the ground)

See our instruction page

This is the tool the competition has attempted to copy but could never get it quite right.  We put our original "Roof Gitter" to work more than a decade ago and are still using it today.  Because it has four wheels instead of two you don't have to make any adjustments.  Whether your sitting on the roof's peak or standing at the soffit the "Roof Gitter" is always spraying at the correct angle, the correct height and the correct pressure and cleans a 20" path.  Whether you use chlorine or sodium hydroxide based cleaning chemicals, our special atomizing nozzles are designed to rinse the toughest stains away while applying only 50 PSI on the roof's surface.  Each nozzle is equipped with it's own filter to prevent annoying and time consuming clogs.

The "Roof Gitter" weighs only nine pounds.  We could make it lighter but it wouldn't stay on the roof.  Any pressure washer with a capacity of 2.5 GPM or better can be used.  However the pressure washer must have a pressure adjusting valve or unloader, as 800-900 PSI at the pump will produce about 50 PSI at the roof's surface.

There is no need to purchase expensive extension wands.  Painters extensions, window washing extensions or just 1" and 7/8" aluminum pipe bought at building suppliers can all be used to push the "Roof Gitter" up and down the roof.  If you wish we can make you a wand, but to be honest, the freight will eat you alive.  The "Roof Gitter" has a bracket and clip that will accommodate a 1" diameter pole with a 3/16" hole drilled in it.

If you prefer to straddle the roof ridge then an extension pole is not needed.  Just let the "Roof Gitter" roll down the roof, pull it back up with the hose, move it over about 18" and repeat

Specifications:

            weight: 9 lbs

            operating psi: 800-1000 pressure washer should have pressure adjusting valve

            gpm: minimum 2.5

            spray width: 20"

            pressure on roof surface: approximately 50 psi   

            hose fittings: adaptable to all pressure washing  hoses

            wheels: 4 lightweight soft rubber, assures consistent 90 degree spray pattern on surface

            nozzles: atomizing with anti clog filters (higher or lower gpm nozzles are only $2 each)

            reach: can be used with up to 24' painter's extension

TO SAFELY AND SECURELY ORDER YOUR "ROOF GITTER" THROUGH PayPal CLICK ON THE "BUY NOW" BUTTON BELOW. (All credit/debit cards accepted)

$279 + $11 S+H

Contact us